Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Proper wiring for 240V elec wall heater with two 120V supply lines
[ 2 Answers ]
I have an older 240V 1000W electric wall heater (no fan, built-in thermostat) which has 2 gray wires for attaching incoming supply. One gray line goes through the thermostat then on to one end of the heating coil itself. The other gray line goes directly to the other end of the heating coil. ...
Connecting Copper Supply Lines to Brass Supply Lines
[ 3 Answers ]
I have just started remodeling my kitchen and am looking to move my kitchen sink further down the wall. The kitchen is completely gutted at this point. The supply lines in my house are all brass. I'm looking to stem off the brass lines using copper tubing. Is it possible to cut the brass supply...
Re wiring existing jacks switching lines
[ 1 Answers ]
I have two separate lines coming into my house. One line operates from two phone jacks and the other operates from two phone jacks. I need to switch one line with the other on two different jacks. The jacks are not the same as each other. How can I re-wire them from one line to the other.
Electrical equipment with coax lines connected backfeeding 40-60 volts through lines?
[ 4 Answers ]
Hi I have a question for any electricians. I am a cable technician and do installations for Cable,Internet,& Voice in homes. What I have encountered a lot is electrical back-feed coming through the copper coax lines feeding from vcr's and tv's in the house which are plugged into electrical outlets....
Tangent lines & secant lines
[ 3 Answers ]
Show that the tangent line to the curve y = x^3 at the point x=a also hits the curve at the point x = -2a. Can anyone tell me if I'm on the right path? I set the function and the slope of a line secant to the functions through the points (a, f(a)) and (-2a, f(-2a)) equal to each other and... View more questions Search
|