Ask Experts Questions for FREE Help !
Ask
    caribbeanlover's Avatar
    caribbeanlover Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 30, 2009, 10:18 AM
    Bryant plus 90i error code 43
    I have a Bryant Plus 90i furnace flashing error code 43. I'm pretty good at fixing it so far. It's 17 years old and I've replaced the blower and inducer motors. All that seems to be fine. I just check the ususal. New filters are in to give max airflow. Checked and cleaned the condensate trap because it seemed like a bit of water was backing up and leaking from the lower condensing chamber. Checked and cleaned the intake screen up on top too. The manual I have doesn't say much about error code 43. Any suggestions? Thanks!
    blahhhhhhhh's Avatar
    blahhhhhhhh Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Oct 28, 2010, 05:40 PM
    This is probably a code 34 not 43. When the led blinks; short is for the first number, long is for the second
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant Plus 80 Error code 33 [ 3 Answers ]

Hello! I'm new on here so bear with me. I found a similuar post on the Bryant 80 but I believe I have a different model... not sure how much that matters. The only model number I could find on the unit was CK5AXA036017AAAA The Error code is 33 Limit or flame roll out switch is open. The furnace...

Bryant plus 90i code 34 [ 9 Answers ]

Bryant plus 90i. A 355 mav I believe. Will not ignite. I get code 34 then code 14. I have read the codes and have tried cleaning the flame sensor, blowing out all the condenser tubes and the green wire ground wire is connected to the chasis. I have taken the flame box cover off and it still didn't...

Bryant 395cav error code 24 [ 1 Answers ]

I have a bryant 395cav042091 +80. Got a new puppy that chewed up the thermostat lead to the cenral air unit outside. I repaired the wires leading to the central air but the furnace is flashing a code 24 (secondary voltage fuse is open) and nothing works. Tried Disconnecting thermostat leads and...

Bryant plus 80 error code 31 [ 1 Answers ]

Bryant Plus 80 furnace - Error code 31 What are the corrective measures to put this furnace back to producing heat? There is power, the fan works but there is no heat. We lost power recently but it worked after that. Last evening there were high winds which were indicated on the code...

View more questions Search