Ask Experts Questions for FREE Help !
Ask
    rockmiester's Avatar
    rockmiester Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 17, 2010, 08:29 AM
    How do I remove a pump from a well with no shut offs?
    Electrical is disconnected. 2 pipes leading to the well with unions.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Oct 17, 2010, 09:31 AM

    Do you have a surface or submersible pump? Why are you pulling it? Let me know, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Need to replace shut off valve under sink - how to remove? [ 7 Answers ]

Our home came with shut off valves that are permanently attached to the supply line. The line is now leaking so we need to replace the valve and the line. I have the water to the house shut off, but can't determine how to remove the valve. I'm attempting to attach a photo... ...

Remodeling and need to remove and shut off old pipes [ 3 Answers ]

I am remodeling an old room that at one point must have been a bathroom. I would like to cut the old toilet pipe off flush with the floor and seal it. I do know that it is connected to the septic system. What I need to know, is if there is anything I can pour inside to seal it off without damaging...

No shut offs in a shower stall? [ 28 Answers ]

I am trying to remove an old shower stall to put in a closet and I opened the access panel and there are no shut off valves. How do I shut off the feed but not the entire house because I am not putting in another shower at this time?

Water shut offs [ 3 Answers ]

Hi, I am trying to replace a leaky faucet in the bathroom. The shutoffs under the sink, are not thresded, but screws into the knob. I can take them all the way out and not have a leak, which also means I am not shutting off the water. I know I can shut off the entire house, but not sure which...

Shut offs [ 2 Answers ]

I am installing a few shut offs.. ball valve type. My question is, do the "lever"s have to be positioned at the top of the valve? Can the be mounted on the side or down... the valves will be installed horizontally.. Thanks.


View more questions Search