400 amp fused disconnect 3 phase outside

tonypeavy Posts: 2, Reputation: 1

New Member

Oct 15, 2010, 09:06 AM

400 amp fused disconnect 3 phase outside

In the inside of the store . I have 2 200amp mlo panels being feed with 4/0 thhn wire is this right

stanfortyman Posts: 5,598, Reputation: 279

Electrical & Lighting Expert

Oct 15, 2010, 11:09 AM

Could be. Depends on several factors.

Why are you asking?

Add your answer here.

Check out some similar questions!

Non fused 60 amp disconnect [ 4 Answers ]

I need some advice on how to wire a non-fused 60 amp disconnect. I will be using it to disconnect a heating element. My question is this: There are two line and load posts. I am assuming the two load post will go to the element, but I am not 100% sure. I am using 6-2wire. Any assistance would be...

Factory installed jumper inside 3 Phase disconnect [ 7 Answers ]

I have a 3 phase 30 amp disconnect switch that was sent out to a job, it is being used as A disconnecting means for a fujitsu mini split air conditioning system which is a 1 phase 208 volt system. In the disconnect there is a # 10 jumper between the load side of B phase to the line side of A...

400 amp service disconnect [ 1 Answers ]

I am installing a 400 amp service (non-residential). Outside of the building I want to put a Combination Service Entrance Device (meter main) with two 200 amp breakers. These breakers will feed two 42 circuit load centers located inside and directly behind the CSED. Do I need main breakers in each...

400 amp service with 2-200 amp panels & 320 amp socket [ 6 Answers ]

Hi TK. I am running 400 amp service into my new contruction home. The electric compnay is running a single 400 amp line to the meter. I have to split it to the two panels at that point. You had told me once before that I need a 320 amp meter socket and then run 2-200 amp lines to the separate...