Is there someone who could tell me where the transmission vent would be on a GM TH350

7up Posts: 180, Reputation: 1

Junior Member

Oct 11, 2010, 05:00 PM

Is there someone who could tell me where the transmission vent would be on a GM TH350

biff26 Posts: 28, Reputation: 4

New Member

Oct 12, 2010, 05:14 PM

Top of transmission case 1/3 to 1/2 of the way back from the engine. Has either a plastic vent or a steel tube (possibly has a rubber hose on it if it is in a truck)

Add your answer here.

Check out some similar questions!

Auto transmission will not downshift in pontiac sunfire 3 speed transmission [ 0 Answers ]

My car Pontiac Sunfire with a 3 speed automatic transmission will not downshift. I already replaced and adjusted the shift cable. It upshifts with no problem and will go as fast as I give it gas. What could the problem be? Thanks!

I need an adapter that goes between my TH350 and my NP203. [ 0 Answers ]

I have just put a 327 cid, came out of a 63 corvette, into a 73 GMC Sierra Grande. The transmission I have to use (because of money)is a TH350. I have an NP203 that I have no clue what it came out of. The truck was made for 4x4 but the output spline from the transmission is too long for the NP203...

Engine swap from 250 to 327 with TH350 Tranny suggestions. [ 2 Answers ]

I have been having problems with my 76 Nova's cooling system. After trying several times to fix the problem, it finally went up to a temp of about 350. There was smoke coming from around the valve cover and head (straight six). I'm tired of working on this engine just to have something to mess up...

Condensation Build-up under Vent where Furnace vent exits Roof Line [ 4 Answers ]

I had a small water stain appear on my roof this winter and went up in the attic to find frozen condensation below the vent where both my water heater and my furnce exit the roof top. Do you have any suggestions on what could be causing this and how to rectify the situation.

Vent diagram - does this meet code (see pic)? Vent runs below actual drain [ 4 Answers ]

The schematic below should make it clear the configuration I would like to use. Basically, I would like to keep the vent under the floor for a little ways, so it pops up in a better location. I cannot easily move the 2" drain location going down and would rather not go straight up from the...