 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How to wire a thermostat in the aquastat relay type L8148E?
I have purchased a Honeywell thermostat RTH2310B1010 and would like to wire it to my honeywell boiler relay L8148E but the wire codes do not match TV W T on the relay and W Y G on the thermostat , what is the procedure to wiring this combination?
Thanks! |
||||
Check out some similar questions!
Purchased a LG LW2510ER window air conditioner for emergency conditions (ie.. main AC just died) the only 120/240 plug I know of in the house is the dryer plug. Trying to build an extension cord to run the dry power to this plug but not sure how to connect the 3 wires to each other. Air conditioner...
Just had a L8148 installed- Plumber left and 10 minutes later I noticed scent- Took the face plate off- noticed the coils all fried- He is returning this evening- Just curious as to likely issues. Thank you.
I have a dunkirk boiler pwb-5d , and an aquastat L8148e. The flame rollout sensor grounded out against burner. From a melted wire. In turn caused the switching relay to click on and off rapidly.I fixed the wire on the rollout sensor. Tried to turn on boiler and nothing happened. So I thought the...
Dunkirk boiler pwb-5d , and an aquastat l8148e. Replyed After checking to be sure no other control is wired into the aquastat and has failed replace the aquastat contro always double check all circuits Don't know how to reply to the answer so I am doing it like this , So can I safely run the...
I just purchased a totaltouch P286-1300 which I know is a little bit of over kill for my system, but I like the way it looks. Anyway, I just a simple two wire baseboard gas heating system. When I connect the wires the screen lights up and comes on just fine. When I use the system the thermostat...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
