 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Model GMPN060-3 Randomly comes on and off at will,
Just air, not heat. Even if the thermostat is removed. Just air, not heat. Heater man said it was the circuit board needing to be replaced. True or not? Cost of circuit board is $368. Could it be something simpler? Heater is about 15 years old... or more? When unit comes on, just fan.. Thermostat has no control over the heater which has gone wild.
|
||||
Check out some similar questions!
Hi, I have a Goodman GMPN060-3 gas furnace. I get a 5 blink diag code, the indoor blower comes on. It worked OK for 3 hours this morning, I had to have the board replaced back Nov 04, I am wondering if it is going bad again, I am on disablity with limited income, any help will be gratefully...
I have a Goodman Furnace Model GMPN060-3. I get three blinks biagnostic code. I changed venter (motor assembly) and pressure switch. Still the same three blinks. Moisture drain path is clean and free of debries. After the new parts, furnace started once, but would not start again -- same three...
I found the little top overtemp breaker tripped and I reset it. Then called for heat and all worekd well for a minute. The flames were going nicely into yhe heat exchanger and then the house circulation blower came on , but this caused the flames to be pushed back into the box and sure enough it...
I have been in my house for 5 years when the thermostat calls for heat, the inducer blower comes on and almost immediately I hear the pressure switch click and then the relay on the main board clicks and the inducer blower goes off. This happens over and over for a couple of minutes and finally...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
