 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a question about my gas furnace.
My furnace has an electronic ignitor. When I first turn on the furnace, the electronic ignitor lights the pilot and I can see the flames. I have the furnace set on auto and once the heat reaches desired temperature the furnace shuts off. However, I can still hear the motor going but the furnace will not kick back on. I will then have to shut off the power to the furnace until the motor stops completely and then after a few minutes I turn it back on. The furnace will kick back on and start heating again. In order to keep it running longer I have had to set my thermostat at 82 degrees. Why won't it kick back on automatically?
|
||||
Check out some similar questions!
Gas furnace doesn't come on the fan for fresh air/exhaust and pilot light comes on but gas valve not letting gas in to burner so it doesn't light,but if I turn off power and back on three or four times it will work until house cools and need heat again
I have trane gas Furnace and its stopped working the pilot is not working its keep shutting off and also the switch on and off is working but the pilot and burner is not working what should I do ?:(
We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:
Hello all, I'm not sure whether to ask this question in the heating forum or here, but it seems to be more a piping question. I am installing a gas fireplace. I got it used, and pieced it together from two sources, meaning I'm needing to change a few things. The burner I got was configured...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
