Ask Experts Questions for FREE Help !
Ask
    Johnrod's Avatar
    Johnrod Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 1, 2010, 08:05 AM
    What causes a hammering like motiom .
    I live in a home supplied by well water.when you try and get water from refrigerator the line behind refrigerator shakes like a jack hammer and gurgles like trapped air.the appliance repair guy said it is a problem w/house supply.
    When upstairs showers are run you get fair pressure but same gurgleing sound and whistling from shower head.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Oct 2, 2010, 07:54 AM

    Sounds like water hammer in the ice maker line to me. Let's recharge your air chambers.
    "Water hammer" happens when you abruptly shut off the water. Such as a electric valve on your ice maker. You have at least 40 pounds of pressure pushing the water flow. The weight of the water hitting a 90 degree bend causes the sound that you hear. We put in air chambers to cushion the hammer much like the shocks on your car.
    Back in the 60's we were required to to put air chambers on all bath lavatories and kitchen sinks. Over time water and condensate built up in them and they must be recharged. First turn off the house at the main house shut off valve. Then open hot and cold faucets at the farthest bathroom to prevent air lock.(This is important.) You will find under each fixture little brass or chrome valves. These are called angle stops. With a small pail held under the angle stop to catch the run off look under the handle of the stop and you will see a nut with the stem running through it. This is called the bonnet packing nut. Put your wrench on it and back it off counterclockwise. Now open the stop and remove the stem and washer assembly, The stop will began to drain. When it has quit draining reassemble the stop and move on to the next one. Do this on each one of your angle stops. There will be six of them in a two bath home. When you are done, close off the faucets you have opened, turn on the water to the house, and give yourself a pat on the back.
    You have just recharged your air chambers and saved yourself a hefty service call bill. Hope this helps you out and thank you for rating my reply. TOM
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #3

    Oct 2, 2010, 10:23 AM

    What type well tank do you have? If it is a galvanized pressure tank, do you have a automatic air control valve on it?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Water hammering [ 2 Answers ]

When ever I try and flush a toilet, and turn on a faucet at the same time I get very little water pressure and also get a hammering sound. I have a water pressure regulator at the water inlet. Could it be bad?

Hammering pipes [ 6 Answers ]

I'm living in a house 3.5 years old. Over the last 2 months I've starting having a problem with one bathroom sink. It's located on the main floor. When using the hot water faucet at about 1/2 open, the pipes hammer. The pipes are hammering in the bathroom itself. It does not occur on the cold...

Pipe Hammering [ 2 Answers ]

I have a loop of 3/4 and 1/2" copper pipe that makes a slight hammering sound while being used and sometimes when unused but perhaps the hot water heater fires up and pipes hammer. It is not a real loud hammer and it does not bother me but my only concern is, could this slight hammering cause any...

Water hammering [ 1 Answers ]

I recently closed the supply lines to both my commodes for approximately two weeks to avert any water accident while I was away. Now every time they are flushed there is a loud machine gun like banging both at the area of the commodes and in the kitchen sink/dishwasher area. I open the fawcets in...

Hammering in pipes [ 2 Answers ]

In order to clear a sink drain clog in an upstairs bathroom this weekend, I needed to remove the shutoff valves to get clearance to remove the P trap. This entailed turning off valves in the basement for the lines that supplied the upstairs bathroom. Everything went back together again and, after...


View more questions Search