 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Heil furnace problem
I got a furnace that's about 10 yrs old , smart valve was bad so replaced it,after powering it up everything works fine until I put the outside cover back on and it stops working, thought might not have enough line pressure coming in, checked and its OK. Take cover back off and furnace works fine. Anyone ran into this one.
|
||||
Check out some similar questions!
I have A Heil Furnace that starts up just fine Model #NDG1075DFo1, but after its running for 5 minutes or so it gets another call for heat, fills the gas box with naatural gas and re-lights this mix pretty violently. This may happen a few times during the heating cycle until the thermostat is...
Fan runs even with the t-stat off
I have a 10 year old Heil furnace. When the furnace tries to come on the combustion fan comes on but nothing happens after that. The pilot does not come on, no flames, nothing. I hired a service tech and he said that we need to change the gas valve since it faulty. Is there anything else I...
I have bought a house with a furnace and I cannot get the pilot to light. I am asking for some type of manual so I can figure this out. The model is VG-80MD-1 and the serial is H73838067. The house was built in 1977 and I am sure this is the original Thanks for any info
I have a Heil outdoor Gas/AC pack model #NPGAD24D1K3 approximately 10yrs old. Unit works great as always at heating the house. The unit cycles normally; however recently I noticed that in between heating cycles the exhaust blower turns on and off repeatedly about every 10 seconds. Approximately...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
