 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Toilet Instalation
We have recently had our foundation repaired with a jacking system. The toilet was never reconnected after a plumbing test and we have now purchased a new toilet for that bathroom. It appears that the drain under the toilet may be lower than it is suppose to be for the toilet to be installed. My first question is:
1. How far below the tile floor should the pipe end be" And 2. How do I extend it if it is too low? Thank you |
||||
|
||||
|
The flange(wider part at top of pipe) should be about 1/4 inch under the tile, then use a rubber or preferably wax ring for toilets, set the toilet down on it, and lift it up again, if the wax is speading out a bit, you are OK, if the wax is completely flatened you are to high. If you are too low go to your local hardware store and get a flange extension kit, it comes with different thicknesses to accommodate the height you need, screw that into existing flange and your done...
Gunsguy |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
How do you get the lower drive belt around the belt keeps to get it on the crankshaft pulley?
My Canon printer was not printing proper color so I went to the help page which advised me to click on the maintenance tab. Looking under "programs>Canon i950 I couldn't find any page with printer controls. I uninstalled the program thinking that by reinstalling it the page with those functions...
Hi, Just recently (last few days) my toilet in the basement bathroom has begun to bubble. This is caused when one of the upstairs toilets (directly above it) flushes but not another one upstairs. It also bubbles quite rapidly when the clothes washer drains. The washer is located in the...
I have a new Hampton Bay Ceiling fan. It has a remote control that I need to install. There are the "main" power wires on one side. black white and blue. I know what to do with these. On the other side of the remote are two more wires. Red and white. I am not sure where to connect these. There are...
Hi pals If we have to install a file in all the systems in a lan then do we have any shortcuts so that if we install in one system it can be used in all other systems , like can we install a file in a netwok?
View more questions Search
|
