 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How high canI place roof vents for a Trane gas furnace
I have a Trane XR90 propane furnace and my question has to do with venting.
Currently there are two vents on the roof one exhaust the other for incoming. The exhaust vent is about 3ft and the input is 2 ft. The vents are near a valley formed by the house roof and the garage roof (like a V). I am concerned about snow build up to cover the input vent. How much higher can I raise the pipe for both vents? |
||||
Check out some similar questions!
Heater locks out and shuts down after a couple minutes due to high winds according to repair service. Installed high wind vent cap but no better results
I was told by a Trane technician that either my high limit switch or the fan relay was causing my problems. The relay is on the control board, but where is the high limit switch
My furnace kicks the burner off when the fan starts. After 30 seconds the burner comes back on and then it runs through its cycle pretty much like it's supposed to. I was told by a Trane technician that it could either be the control panel orthe high limit switch. Where is the high limit switch...
We are thinking of replacing our furnace with a high efficiency one. Ihe brand we are considering are Rheem, coleman and Trane, however, would like some feed back which brand has the best value, reliability and performance.
I have trane gas Furnace and its stopped working the pilot is not working its keep shutting off and also the switch on and off is working but the pilot and burner is not working what should I do ?:(
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
