Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Carrier furnace: limit switch fault furnace has ignition but blower will not come on?
[ 2 Answers ]
Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?
York Stellar Furnace Heating up Furnace Room to 110 Degress?
[ 2 Answers ]
I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...
Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks
[ 3 Answers ]
I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.
Furnace Blower Motor Runs Constantly & Furnace or AC Won't Run
[ 2 Answers ]
I have an Armstrong forced air (induced draft) natural gas furnace with central AC (made around 1990 -- Model: EG6H80DC14-1, Serial: A18315MNA). I had a problem at the end of the heating season where the blower motor would run continuously (even when the thermostat is turned to "off"). I thought...
Furnace not heating the house. Damper on the furnace not opening. Motor then shuts.
[ 4 Answers ]
My forced-air furnace is not working correctly. The gas works heating the air in the furnace, but When the motor starts the damper doesn't open and the Motor shut down. I need suggestions?:mad: View more questions Search
|