Ask Experts Questions for FREE Help !
Ask
    eklojoe's Avatar
    eklojoe Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Sep 1, 2010, 01:31 PM
    Troy bilt bronco won't start
    I have a Troy Bilt Bronco and when you turn the key nothing happens. The same thing happened last year while it was under warranty, so I called place where it was fixed and they told me it was a blown fuse. In an answer you wrote a couple years ago, you said there were two fuses. I only found one around the battery box (which was good), but no other one. When I wrote to Troy Bilt they said there's only one fuse and I should take to a repair shop. I hate to pay a couple hundred bucks just to have someone change a fuse, if that's the problem. Can you help me?
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    Sep 1, 2010, 08:01 PM

    There's only one fuse,but I would check my battery and connections before I took it to a shop
    eklojoe's Avatar
    eklojoe Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Sep 1, 2010, 08:03 PM

    Thanks. I'll make sure they're tight.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troy-Bilt Super Bronco 13AX60TG766 [ 2 Answers ]

Does anyone have a maintenance manual available for subject riding mower? Our RC club mower's drive pedal is now extremely hard to push down all the way. A helpful user on another forum suggested it may be the variable speed pulley hanging up. He offered advice on how to check this by removing...

Troy bilt bronco keeps dying [ 3 Answers ]

My 2004 bronco has just started to die on me after cutting about 3/4 of my half acre yard. It runs fine and then as if it has bound up it sputters and then dies. I wait a minute and it restarts and will make about one pass before it does the same thing over again. Here's what I done so far: new...

Troy Bilt Riding MOwer (Bronco) [ 4 Answers ]

Hi, I have a troy bilt riding lawn mower (42 inches deck) bought last year. I am looking to put a bagger with chute on it. Do you know if a Craftsman bagger ( 6 Bushel 2 - Bin Hard Bagger for 42" Deck ) will fit? I know all most of the available mowers in the market are built by MTD, do the...

Troy Bilt Super Bronco [ 1 Answers ]

Looking for a diagram of a Super Bronco deck. Had to replace a tension spring but don't think is in the correct place. The diagram in the manual isn't too clear on the springs placement. The belt is very loose and doesn't have the cutting power it used to.

Troy Bilt Bronco Weedeater [ 1 Answers ]

Problems with starting our Troy Bilt Weedeater. Less than a year old. Hard to start And once it starts, automatically shuts off as if struggling for gas. We have cleaned and changed spark plug and Changed oil mixture... Any Suggestions? Thanks, Kim & Ed

View more questions Search