 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
4x4 4H does not work on my 2008 Ford Ranger
My 4x4 4H does not work but 2H and 4L work. This is on a 2008 Ford Ranger. I was told to take the electric motor that is hooked onto the transfer case and see if that is the problem but have not done this as yet. Has anybody else had this problem before. Thanks
|
||||
Check out some similar questions!
Does the harmonic balancer need to be removed to install a new timing belt on a 4 cyl. Ford motor 2.3 1995
2001 Ranger. I found dangling down from left side rear a hose with a cilp. It was attached to the axle housing. What is it for and where does it go. It just appears to be some type of air hose but is not attached to anything at other end. Should I be concerned? Thanks
I have a 91 ford explorer 4.0 that for some reason is getting spark to the 3 plugs and cylenders on the drivres side, yet on the passenger side it has compression and spark but when the plugs are pulled, the engine stays the same. It is running on 3 cylenders and I can't figure out why. Can you...
Anyone, what problems does the Check Engine light going on usually indicate? I was coming home tonight, about an hour highway drive and the light momentarily came on, then off, on and off. Not a flicker, but for several minutes at a time. Truck is VERy reliable and there is no indication that...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
