Pilot will not light on interherm furance

Check out some similar questions!

Propane Furnace won't start no pilot light red light flashes 3 times [ 6 Answers ]

My propane furnace G6RC has no visible flame and the red light either stays on or flashes 3 times in a row and then the furnace shuts off and tries to restart

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

How to light a furance pilot light [ 3 Answers ]

My pilot light on my furnace need to be lite and not sure how to light a pilot light, I see the knob to turn that say on, off and pilot but not sure where to hold to fire and not sure if I need to hold the knob down that say pilot at the same time please help.

Old floor furance pilot/valve opperations [ 1 Answers ]

]Iam helping my nabor light her old floor furance.I using a long wire with a wood match I got the pilot lit.when I turned the valve there was a small blast inside the furance no damaage. So I don't want this to happen again.this furance is about 18" deep has a glass for the pilot and two valves on...

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...

View more questions Search

Check out some similar questions!

Add your answer here.