Ask Experts Questions for FREE Help !
Ask
    tableclocks's Avatar
    tableclocks Posts: 432, Reputation: 2
    Full Member
    		  
    #1

    Aug 6, 2010, 11:13 AM
    Alumiun brake to brake sheet metal
    Will a 8 ft alumiun brake be OK for 28 ga gal sheet meat to make some duct ?/
    Thank you
    kryostar's Avatar
    kryostar Posts: 108, Reputation: 11
    Junior Member
    		  
    #2

    Aug 6, 2010, 11:05 PM

    Yes I think it should handle it OK, you should be able to feel if your damaging the brake when bending sheet metal heavier than it was designer for.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search


Check out some similar questions!

I have a 93 caravan 3.3l and the abs and brake lights are on and the brake pedal stif [ 1 Answers ]

I have a 1993 dodge caravan 3.3l with 113k and the brake and abs lights are on and the pedal is stiff. I just finished a brake job on it and the lights are still on and pedal is still stiff. How do I fix this problem

Changed 2000 camry brake light switch, but still will not shift and no brake lights [ 1 Answers ]

My sons 2000 Camry stopped shifting, no brake lights and no cruise control. I changed out the brake light switch, but it still does not work? Any ideas, please. Thanks

1996 dodge ram abs brake light is always on even though the park brake is off [ 3 Answers ]

I have a 1996 dodge ram 1500 and ABS brake light won't shut off even though the park brake isn't engaged could that be the ABS sensor need to be changed ?

How to calculate "brake even point" in balance sheet [ 1 Answers ]

How to calculate "brake even point" in balance sheet

Emergency Brake light stays on after brake is realeased [ 3 Answers ]

What would cause the emergancy brake light to stay on after the emergancy brake has been released on my 2002 Ford Explorer?

View more questions Search