Ask Experts Questions for FREE Help !
Ask
    cade0314's Avatar
    cade0314 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 3, 2010, 08:05 AM
    Water spraying threw brand new stem in bathtub
    I replaced all of the stems washers and o-rings but water is coming out strong threw the hot and cold stem hitting the back of the handle and running on the floor
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #2

    Aug 3, 2010, 10:55 AM

    Cade314...

    You obviously did something wrong. Check your installation.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #3

    Aug 3, 2010, 02:26 PM

    Tighten bonnet nut.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #4

    Aug 3, 2010, 04:33 PM

    If you valve is a stem and washer assembly faucet (see image) Then Harold nailed it.
    Open a handle until it starts to leak. Now snug up the topmost packing nut until the leak stops, Careful!! don't over tighten.
    Good luck, Tom
    Attached Images
  1. File Type: pdf Shower Valve.pdf (102.0 KB, 109 views)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can't identify brand type stem valve to shower [ 14 Answers ]

Can someone possibly identify the make of my stem valve.. . most likely the original in a house built in 1960. My cold water valve leaks through the shower head. The brass is broken & cracked all around the rubber seal at the end so replacing the seals doesn't help. I thought it was a...

Bathtub faucet stem removal [ 6 Answers ]

Hi, I'm trying to fix a leak in my bathtub faucets and was expecting to unscrew the stem "holder" (sorry, I don't know the name of the part that the stem and the packing felt sits in) to replace the seat and washer. However, what I discovered was that there is no stem "holder" and that the stem...

Leaking bathtub faucet Hot water PF brand 14 years old [ 12 Answers ]

Our bathtub faucet is leaking a lot. My husband has replaced the stems and it stops for a little while then starts again. Any suggestions what we can try? I'm not sure if it is related but now the kitchen sink has lost a lot of it's water pressure, but that's the only place. Any help would be...

Stem problems in bathtub [ 3 Answers ]

I was wondering if a novice could get some advice. I have an old home and with it an old plumbing system. I have faucet knobs for my shower and 2 for my tub water. The hotwater knob for my Shower started to spray water from the stem. I took it apart and exposed the Cartridge and after that it...

View more questions Search