Ask Experts Questions for FREE Help !
Ask
    lynchwf's Avatar
    lynchwf Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 29, 2010, 04:37 AM
    I have a M1MB furnace where is the fuse located on the mother board?
    No pwer to unit breakers OK but manual says check fuse on board where is the fuse?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Jul 29, 2010, 09:47 AM

    Most plug in, like the automotive type, if it has one look a little harder not all furnaces have one
    Maybe if we had a brand name and model number could help you better
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #3

    Jul 29, 2010, 09:58 AM

    I blew up a picture of your circuit board,, could not see a fuse

    It might have a inline fuse,look at your wiring diagram,it shoulsd show if and where a fuse is located

    Have you checked with a meter to make sure there is power at the furnace ?
    If not, possible bad breaker

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Nordyne M1MB furnace will not start [ 2 Answers ]

Hello I am hoping someone could help me on this site. It looks to be very friendly and helpful! I have a Nordyne M1MB gas furnace that blinks twice which means the pressure switch is stuck open with the inducer blower on. This is about all the information I can find so far. I am wondering...

Where is the 3 amp fuse located in a rheem furnace [ 2 Answers ]

Where is the 3amp fuse located in a rheem furnace

Miller gas furnace mother board [ 2 Answers ]

How you know that mother board is bad

BRYANT Furnace blowing 3-amp fuse on control board [ 1 Answers ]

I have a Bryant M/N 383KAV036070AGJA, S/N 3097A08913, Series G furnace with central air that is blowing the 3-amp fuse on the control board. The furnace has been serviced numerous times over the past two years for various problems by multiple service companies. The control board was even replaced...

Furnace control board fuse keeps blowing [ 1 Answers ]

Hi, I have a Carrier furnace 48GS-036090311TP with a Honeywell T8401C thermostat. I can run the fan on continuously but when I put the Heat to ON on the T-stat, the 5 Amp fuse on the control board (LH33WP003A) in the furnace blows. The sequence is like this: 1. Fan only operation is running...


View more questions Search