Ask Experts Questions for FREE Help !
Ask
    BigT66's Avatar
    BigT66 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 18, 2010, 11:14 AM
    Conntecting vennmar hrv he 1.3 to a infinity controler
    I have a carrier infinity ics gas furnace with a vennmar hrv he 1.3. I just had the carrier inifinity controller installed, and noticed after the cooling call the blower shuts down as well. After 5 minutes it starts up again. The hrv was and still is interlock to this furnace
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Jul 18, 2010, 01:45 PM

    Not sure what your asking.

    The installation may require a NIM or Network Interface Module.

    It provides Y, G , R and B.

    These are probably standard furnace signals, but not sure.


    Just not sure. Not enough info in Carrier's datasheets. They like you to use their products.

    See: http://hvac-talk.com/vbb/archive/ind.../t-117744.html
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Does my Range hood need an exhaust to the outside if I have a ducted HRV installed [ 2 Answers ]

I have a ducted Heat Recovery Ventilator installed in the basement. Installer says I do NOT need to have an exhaust duct from my Range Hood because the HRV does the trick. An inspector tells me I MUST install an exhaust duct from my range hood because Recirculating range hoods are unacceptable...

Wire HRV to control Furnace Fan [ 7 Answers ]

I have recently installed a Venmar HRV. The control panel for this unit offers an Automatic setting where the unit will stop for 40 minutes and run for 20 minutes each hour. I would like to connect the HRV to my furnace so that it turns the furnace fan on for this 20 minute period. How can I...

Three zone controler interface [ 5 Answers ]

Hello I have a vision pro 8000 thermostat-2 hooked to a three zone controller tied to a 2 stage gas furnace and a 2 stage heat pump. The heat pump works but the gas will not come on unless I change the zone controller from heatpump to conventional. Then the a.c. comes on instead of the heatpump on...

Summation from -infinity to infinity [ 6 Answers ]

how do u find the value of 'sigma' from n=-infinity to infinity for (1/2)^(2 mod n).. sorry wasn't able to put it in the right format..

Hrv intertherm gas furnace,mobile homes [ 3 Answers ]

Does the above mentioned furnace come with a built in hrv?

View more questions Search