Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Troubleshooting submersible pump problem
[ 4 Answers ]
Hello! I am having a little trouble with a submersible pump. It pressures up to 28 pounds (it should pressure to 50 pounds) and then it just sets there. Can't seem to get any more pressure but the switch doesn't seem to be doing anything after it reaches the 28 pounds. I have watched it and I can't...
Two questions pool pump & submersible well pump for irrigation in river
[ 3 Answers ]
Have a inground pool about 5 yrs old that we replace motor every yr,the wireing & amount of juice is OK it's the sealed bearings that start squealing an freeze up, 2ND ? The well pump is 220v / 2 wire direct to breaker ,its on or off nothing fancy an has worked for years except this yr ,runs...
Submersible well pump troubleshooting
[ 1 Answers ]
Hello: [email protected] We lost electrical power for about 24 hours on my submersable well pump. I can not get any water to rise out of the well. The pump sounds to be fast cycling so I shut it down. On opening the line from the well before the holding tank there is no water present. ...
How can I get the old submersible pump out?
[ 3 Answers ]
Hi, I asked the submersible pump question a while ago and speedball1 helped me a lot. I have additional question now. I have located the well. Can you tell me the steps to pull the pump out? Is it doable for an layman like me? I am pretty comfortable to explorer things but would like to... View more questions Search
|