Bryant furnace model number 518A036

debhora Posts: 1, Reputation: 1

New Member

Jul 6, 2010, 02:42 PM

Bryant furnace model number 518A036

No wiring diagram on panel door. Not having much luck retreiving one.

Stratmando Posts: 11,188, Reputation: 508

Uber Member

Jul 6, 2010, 03:18 PM

Are you installing a Thermostat, Changing a Motor or what? May be able to help another way.

Add your answer here.

Check out some similar questions!

Bryant furnace model 376cav, error code 24. [ 7 Answers ]

I am getting error code 24 on my bryant furnace. Could someone please help me by letting me know what the code is, and how to fix it? I was trying to install a new thermostat and might have got wires crossed. Thanks

Bryant Furnace model 383KAV won't kick on [ 10 Answers ]

I'm not getting any error led blips from the computer board. I can only see one limit switch which isn't tripped. I replaced the thermostat but that wasn't it. I've checked breakers and even tried tripping them off and then back on. Usually if I remember right this furnace goes through a...

Bryant furnace model 310 AAV/JAV [ 3 Answers ]

Thought the thermostat was bad so replaced the thermostat, sounds like it clicks on but not blowing of the air, and the red light still blinks 2 shorts 4 longs, pilot light also won't come on now. Have done the swith where you turn it off for 5 minutes, still trying to troubleshoot, could use...

Bryant Furnace Model # 582ANW024060AAAD [ 3 Answers ]

Bryant Furnace Mode No. 582ANW024060AAAD furnace after running for about 30 min. backfires and eventually the furnace will stop while the blower continuos to run. To be able to restart the furnace you have to turn off the breaker and furnace will backfire again before it will stop. >Moved from...

Bryant Model 350MAV Furnace [ 3 Answers ]

Hi, I recently had a furnace repairman in who told me our inducer on our Bryant Model 350MAV furnace needed to be replaced. He said the total cost would be $1075.00, including $890.00 for the inducer. This seemed high to me. Can anyone give me an idea of what this repair should have cost,...