Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Electrical transfer switch
[ 4 Answers ]
I have a 2 pole 60 amp Manuel transfer switch. I am installing a 2 pole 60 amp breaker in my main panel with #6 wire ( 2 hots and a neutral plus ground) to feed the 2 pole 60 amp transfer switch. From the main lugs on the 2 pole 60 amp transfer switch I am feeding a sub panel with #6 wire ( 2...
Transfer Switch
[ 2 Answers ]
How do I wire a tranfur switch for a portable 6300 watt generator coming from the Main panal to the tran tranfur switch do I need a subpanal to also can you give me A diagram also For this I would bring power from a 60 amp breaker in main panal I only want to run afew things...
Generator transfer switch
[ 1 Answers ]
How difficult is it to install a generator transfer switch? It's pre-wired, doesn't look too Difficult. Is there anything I should look out for? The only thing I'm not sure of is it comes with two 15-amp 1-pole breakers, two 20-amp 1-pole breakers, and one 2-pole 20 amp breaker. How do I tell the...
Transfer Switch
[ 3 Answers ]
Ok I am looking to add a transfer switch so I can run my generator when the power is out. I have always been told that my transfer switch needs to be rated higher then my generator's output. The problem is my generator has two output rating stated. In other words, a constance rating of 5,550 kw...
Transfer switch
[ 6 Answers ]
I’ve recently purchased a Guardian 13kw standby generator with a transfer switch and load center panel. I have a couple of questions 1. The transfer panel had a total of 205 amps through 12 various breakers in it, can I replace some of them as long as I don’t go over the original 205 amps and use... View more questions Search
|