Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
I have SS duct (HVAC) to be connected to a Galvanized steel duct. Do I need dielectri
[ 1 Answers ]
Do I require dielectric washers to join the SS duct to Galvanized steel duct in HVAC duct network?
How do I connect duct work if duct tape won't hold?
[ 2 Answers ]
The elbo section of duct work in basement fell down from the duct it was connected to and previous owner had it connected with duct tape. New application of duct tape did not hold it for long. So what is the safest way to connect these two ducts or at least prop it up to the ceiling so it cannot...
Pregnant and clogged milk ducts. What do I do?
[ 6 Answers ]
I did as my midwife suggested and massaged them until they went soft again, but 30 minutes later they began to harden again. What do I do to permanately uclog them? I read about warm rags (which I've also tried) and pumping and massaging. Is it OK to pump them while I'm pregnant? This is my...
Which milk rottens faster soy milk or cow milk and why
[ 1 Answers ]
Which milk rottens faster soy milk or cow milk and why?
Flexi Duct vrs Aluminum Duct
[ 4 Answers ]
I am adding an addition onto my house. The local building inspector has already told me my HVAC unit is more than adequate in size to support the addition. The old duct vents are aluminum. Can or should I use flexi venting in the new part? What are the pros and cons of these two types of vent... View more questions Search
|