Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How do you locate exisitng pipes under a concrete slab
[ 2 Answers ]
I am planning to install a master suite utilizing a two-car carport and a workshop already attached to my home. On the opposite of the only inside wall is a half of bath and in the workshop lives the hot water heater. I would like to know how to locate the existing pipes that I would use to tie in...
Water pipes knocking on upper floor, after pipes burst
[ 7 Answers ]
Hi - recently, my water pipes froze and burst, flooding my basement. I've had the pipes repaired. Now, when I turn on the hot water in my upstairs (2nd floor) sink, there's a knocking/clunking after I turn the hot water off. Its only the hot water (doesn't do it with cold water). When I...
Is it our pipes or leading into the city pipes?
[ 2 Answers ]
Our toilet slowly stopped flushing it will slowly drain as well as the tub and when I use the washer it comes out the toilet. I bought a snake and snaked both toilets on each end of the house. It showed no clogs. We went out for the weekend and when we came back everything worked. Back for one day...
FYI: Technology to locate plastic pipes in a concrete floor
[ 1 Answers ]
http://www.malags.com/getattachment/b0807fef-2630-4316-88ad-5919fbed80ba/Detection-of-Plastic-Pipes-in-a-Concrete-Floor.aspx The technology of Ground Penetrating Radar can locate just about anything, including voids.
Frozen pipes - detecting burst pipes
[ 1 Answers ]
Cold side of the kitchen faucet was frozen this a.m. Trickle returned this evening, followed by an immediate drop in hot faucet pressure - then some brownish water - the brownish water lasted 20 seconds - but the pressure is still low 1/3 pressure now and can get both some hot and some cold Have... View more questions Search
|