Ask Experts Questions for FREE Help !
Ask
    alaskan3's Avatar
    alaskan3 Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 31, 2006, 12:04 PM
    Cold Air
    Hi my furnace is blowing cold air after I had a heating tech replace the inducer. My furnace was making a lot of noise when it would start and shut off and they came and looked at it and took the inducer apart and the wheel was breaking in the middle so they ordered a whole new inducer motor kit and put it in and now my furnace will only blow cold air. I was working just fine until they put the inducer kit in and now it will not heat my house. It will run without shuting off and I let it run for almost three hours the other day and it only heated the house two degrees. I looked at the burners and they are all lit and the blower is working but I'm not getting warm air. Thank you for your help. I have a natural gas furnace it is a Payne 350mav036080

    Tanner
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
     
    #2

    Dec 31, 2006, 12:31 PM
    It should be under a warranty, call them back.
    alaskan3's Avatar
    alaskan3 Posts: 2, Reputation: 1
    New Member
     
    #3

    Dec 31, 2006, 01:30 PM
    Quote Originally Posted by NorthernHeat
    It should be under a warranty, call them back.
    I did and now they think it's my gas valve. I don't see how it can be my gas valve. It was working just fine and then they replaced the inducer motor and now it blows cold air. If it was my gas valve the burners would not light and stay lite would they.
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
     
    #4

    Jan 1, 2007, 12:22 PM
    Quote Originally Posted by alaskan3
    I did and now they think it's my gas valve. I don't see how it can be my gas valve. It was working just fine and then they replaced the inducer motor and now it blows cold air. If it was my gas valve the burners would not light and stay lite would they.
    No it doesn't sound like a gas valve to me either, but it is hard to guess what it could be.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Cold air return [ 4 Answers ]

1930 house 3 stories. Cold air returns go from main floor straight down to basement through galvanized pipe and end about 8 inches from floor. Not connected to anything. Shouldn't they run to the furnace?

Day & Night forced air heater keeps blowing cold air [ 1 Answers ]

Yesterday my heater was working as normal. Today I replaced the filter in my Day & Night forced air heater. Later I bumped my thermostat when walking by it, but I'm not certain that this caused the problem. My heater turned on and blew hot air. I turned it all the way down, but the fan...

Cold Air Returns [ 2 Answers ]

Which cold air returns do you close in the winter?

Furnace blowing cold air [ 3 Answers ]

Ruud oil furnace blowing cold air, fan running constantly

Help no cold air from a/c unit in Florida [ 2 Answers ]

I have a rheem a/c unit with heat pump inside and secondary unit outside and is only 5 years ols. When I woke up late this morning I noticed that the thermostat said it was 82 degrees upstairs and I always keep it at 79 so I knew something was wrong. I turned the thermostat off, reset the breakers,...


View more questions Search