Ask Experts Questions for FREE Help !
Ask
    atripp's Avatar
    atripp Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 25, 2010, 02:53 PM
    Just replaced heating element on kenmore 900series unsure where the black ground wire
    Where does the black ground wire goes. I did not need to remove it to replace element but I did and now I'm not sure where it goes.

Check out some similar questions!

Replaced heating element in Kenmore Dryer-don't know how to hook the wires up [ 2 Answers ]

I replaced the heating element but can't figure out where the wires go back? The manual doesn't say anything about the heating element. There are 3 wires and I replaced it from the front.:confused:

Can I use a ground wire for a ground and live black or hot wire at the same time? [ 8 Answers ]

I only have 3 wires from my ceiling to connect to my fan/light, the black, white and bare ground. No problems setting up in this room to only one switch but I would like to have the duel fan/light switch in like in my other rooms without having to pull a wire from the ceiling down to the switch,...

Kenmore dryer would not heat. Replaced element. Fine. Now it will not turn on. [ 0 Answers ]

I have a Kenmore model 110-62202100 dryer. It would not heat. I replaced the element and it worked fine for one load. Now it will not turn on. I read that this could be the relay or the switch. How do I tell? Thanks, Collin

How do you wire a single switch (1 black 1 white 1 ground) to a 5 wire hunter remote? [ 1 Answers ]

I have an existing ceiling fan operated off a single switch (1-black, 1-white, and ground). I am trying to install a hunter ceiling fan remote (model 27157) with 5 wires (1-black/white, 1-red, 1 black, and 2-white commons). I have tried several combinations of wiring, including the recommended...

How do I wire a switch with pilot light with 1 black, 1 white, and 1 ground wire? [ 1 Answers ]

I replaced an outdoor outlet controlled by an interior switch with a Cooper gfci outlet and it tested fine. Then I replaced the existing switch with a Cooper switch with pilot light. The switch has one line coming into it with one white(hot), one black(neutral), and one ground. When I connect...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.