Ask Experts Questions for FREE Help !
Ask
    Toto95's Avatar
    Toto95 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 22, 2010, 10:45 AM
    John deere stx38 won't start
    I put a new tractor drive belt on the mower, now it won't start. Checked the safety switch, OK, checked the solenod, OK. Found a wire clip with two wires on it on top of the transaxle not connected to anything, one purple and the other gray, tested the one wire and get voltage when the key is turned, can't find any other wire around that area. Also when I turn the key the fuel cutoff switch clicks. Is this wire for another accessory or needs to be connected to something.
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    Jun 23, 2010, 07:41 PM

    If this is a gear drive there is a neutral switch on the tranny that the plug slides on.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

John Deere STX38 [ 4 Answers ]

I am changing the drive belt and having trouble getting the belt around the tension pulley. Is there a trick for putting on the belt? It is a John Deere STX38 (Yellow Mower Deck)

John deere stx38 [ 1 Answers ]

I have a john deere stx38 , has difficulty climbing inclines or hills, runs fine on level ground. Have replaced engine mount bolts Have replaced drive belt Have checked fluid level in transmission Note this is a hydro drive Question: is there another adjustment I can make or is there...

View more questions Search