 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How do the 2 doors/panels go on an RPJ II?
I am in a rental with a Comfortmaker RPJ II ac/furnace and I took the covers off to look at the filter yesterday. Coincidence or not, today I have wet carpet outside the louvered closet that houses it. I'm concerned that I may have switched the doors and am creating this issue but I can't find a picture to guide me.
The bottom has the filter and other thing and the top has the inline fan. Would the louvers go on the top and the flat panel with the 'flash viewer' window in the bottom, or just the opposite? I can't see where the water is coming from; inside the closet is the drain and there's dampness, but not enough to be flowing out into the carpet. First concern though, did I switch the doors and can that be a real problem? Thanks! |
||||
Check out some similar questions!
Cannot adjust shower doors to align correctly because shower walls aren't plumb... the shower bypass doors/rails etc are level and plumb but they leave gaps because the wall of the shower isn't plumb... any way to correct that enough to align the doors? Out of plumb appx 1/8 " on both sides. ...
Cannot adjust shower doors to align correctly because shower walls aren't plumb... the shower bypass doors are level and plumb but they leave gaps because the wall of the shower isn't plumb... any way to correct that enough to align the doors? Out of plumb appx 1/8 " on both sides.
I have a 13 yr old Comfortmaker RPJ II gas furnace controlled by a Honeywell digital thermostat. I have it programmed to turn on at 5:30AM. Lately, the furnace is not turning on (igniting, firing, blowing) in the morning even though its cold enough and the thermostat is sending a signal to the...
I am replacing my bedroom hollow doors with 6 panel pine doors. My problem is that the 6 panel pine doors are not fitting properly. When I hung one door with the same size hinges I was able to put the screws in the same holes as the old ones but the door will not close. The new door is about...
Just changed the control module because not enough voltage was going to the ignitor plug. Then the glow plug needed changing. Worked great for a few days. My 4 yr old messed with the thermostat then the heat didn't work again. Pulled the plug on the furnace to reset, then took the batteries out of...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
