Ask Experts Questions for FREE Help !
Ask
    Dhermes50's Avatar
    Dhermes50 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 6, 2010, 05:02 PM
    What can I use to sand the edge of a corian top down about an 1/8 inch?
    I want to sand the end of my corian counter top back about 1/8 inch. I need to get my refrigertor in and I need to get it back about 1/8 inch.
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #2

    Jun 6, 2010, 05:19 PM

    Carbide bit and a router. Sanding, if necessary can be done with sandpaper using eventually 2500 grit or finer.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #3

    Jun 6, 2010, 05:40 PM

    I'm with KISS, sanding will take forever and you won't get a very straight edge.
    If you don't have a router, Harbor Freight sells a trim router for about $21. Only runs at 20,000 rpm but not a bad trim router. A one half inch carbide bit with 1" cutting edge will cost you about the same. Glue a guide to counter top with hot glue. You won't be able to get completely to the back edge, that you can sand.
    If Harbor Freight not convenient, order online.
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
     
    #4

    Jun 6, 2010, 10:06 PM

    Harold and KISS are right on.

    To do the last bit by wall u can use a right angle grinder(with great care). These can be rented at most big box stores.

    Chuck

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Cutting corian counter top [ 6 Answers ]

What tools and what method can I use to enlarge a corian counter top cut out for a cooktop. I need to enlage the cutout by about 5/16 in in one dimension and 3/16 inch the other. The couter top is about 1 inch thick.

Cutting angles for trim edge on counter top [ 3 Answers ]

I have a rectagular counter top which has one front edge cut on an even diagonal. I need to know how to miter these so the trim can wrap around the outside edge. Would it be 22.5 cuts?8923 8924

Corian counter top repair [ 3 Answers ]

My corian counter top was damaged by heat. The spot is approx. 2 x 3 x 1/64 inches. How can I repair it without making an obvious spat? Thank you for advice.

Corian Counter top installation [ 2 Answers ]

I was given 2 sheets of corian counter top from a builder friend of mine, how do I install and what do I use to cut it?

Sand filter is leaking from top - try to repair or replace? [ 1 Answers ]

I have a Jacuzzi sand filter for my I/g pool - approx age 18 years. Over the last two seasons it has dribbled a bit from the top whenever I change the filter setting (e.g. to backwash, drain, or back to normal pool operation mode). The drips would stop after a few minutes of regular operation. ...


View more questions Search