 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Above ground pool resin vs steel
I was looking for advice on whether to purchase a resin or a steel above ground pool. Are 2 speed filters important in decreasing the cost of electricity? Should the grass be removed from the surface where the pool will be installed. Any recommendations on pool companies that offer good quality at reasonable prices? I live in the northeast on the coast. Thanks!
Deb |
||||
|
||||
|
More than just the grass gets removed. When buying an above ground pool buy the best you can afford. Darn things can hang in there for 20 years so buy the best. How to build-install above ground pool Also read What Type of Above Ground Pool is Best for You? - Associated Content - associatedcontent.com |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I was wondering if I could use mulch to level the ground for my above ground pool. I was told not to use sand, and I have a hard time digging.
I had a very small leak in my liner about just under the water line. Over time it created a 4inch diameter hole (rusted) in the wall. The liner is now concaveed and being sucked into the large rusty hole. Can I repair the wall bey draining the pool, drill holes in the wall and bolt a small sheet of...
I have a 30 year old galvanized steel wall inground pool, Clayton and Lambert. Replaced first liner after 18 years. Small amount of rust at that time which I removed and repainted before new liner went in. Time for another new liner, walls have much more rust now, even a few holes, size of...
Hello, the liner in part of my pool is below the water level and thus water is now behind the liner. I cannot pick up the liner because it is so heavy with the weight of the water. 1. Is this hurting my pool 2. How much to replace a new liner and have it installed for a 16ft round pool ...
We are going to install a new liner in an above ground pool this weekend. I have read conflicting information as to when the skimmer and jet holes should be cut. Do you fill the pool with water within a foot of the skimmer, attach the trim kit and then cut out the liner? I don't know what to do,...
View more questions Search
|
