Ask Experts Questions for FREE Help !
Ask
    garyelder1's Avatar
    garyelder1 Posts: 2, Reputation: 1
    New Member
     
    #1

    May 24, 2010, 05:02 PM
    How do I get the cold water to come out of the shower head on a three handle shower f
    In my shower I have a three handle system. When I turn on both hot and cold the turn the shower handle to divert the water to the head, the hot water comes out of the shower head but the cold water comes out of the water spout. How do I get the cold to go to the shower head?
    KBC's Avatar
    KBC Posts: 2,550, Reputation: 487
    Ultra Member
     
    #2

    May 24, 2010, 05:45 PM
    How old would you say the system is?

    The middle handle in the old styles had washers and seats which would wear out,replacement required a special tool(seat removal tool) and most likely the replacement of the brass screw holding the washer in, sometimes even the cup which surrounded the washer..

    I don't know about new ones,perhaps there is a way to find out what the innards are like without removal,look for the brand name,check online for the maker and try to find the exact system, a diagram might show you the problem, and there might even be a trouble shooting section.

    Otherwise,it's call the plumber time(IMO)

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

The water in my shower will not switch from the shower head to the tub spout? [ 5 Answers ]

I recently purchased a small home, that I am getting ready to rent out the problem is I get water from the shower head just fine, but I get not water from the tub spout, any ideas?

One handle hot and cold water shower and tub control [ 1 Answers ]

I have a one handle that controles my shower and tub to turn on my shower when I pull up on handle that is on top of faucet to send the water up to the shower not much come's out of the shower head and it still comes out of the faucet are the gut's hard to replace and how do I do it sometimes it is...

Leaky shower handle/head [ 1 Answers ]

Hi, OK, I was attempting to fix a leaking cold water shower head. I turned off the water at the road, removed handle & flange. Removed brass thing that was screwed into shower pipe. Took to hardware store, they replaced rubber washer and gave me a tool to remove the seat from the pipe . Well...

Hot water in the shower until shower head installed [ 6 Answers ]

I have hot water in all my other faucets/showers. I also have hot water at the particular shower with the problem as long as a shower head is not installed. When I install the shower head, the water is lukewarm. Any ideas for the source of the problem, and how to fix?


View more questions Search