Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
Heat pump troubleshooting
 [ 0 Answers ]
 Low pressure switch shuts down unit. Jumped across low pressure switch so unit will run. High pressure side is 270 psi low pressure side is 0 psi. I believe the unit is low on freon but the HVAC tech says it's a bad expansion valve ( that he replaced 2 years ago ). What do you think. George 
Is Meyers pentair sewage ejector pump model SR1830 a quality pump?
 [ 1 Answers ]
 Just installed a sewage ejector pump and I'm somewhat concerned about the manufacture. Not seeing very much information about Meyer. I see Zoeller and Little Giant, so I'm wondering if I got a quality systems. Considering all that was required to get the system in I don't want to revisit this for... 
Sewage Ejector / Septic smell troubleshooting.
 [ 1 Answers ]
 Hi. I am trying to gather some "What to do next" type advice.. Purchased an older Ranch home from the mid 60's with septic system and separate Holding tank / ejector pump in basement. All plumbing connects together into a wall cavity near the septic tank. This is where we get our smell. It... 
Sewage pump/ejector pump
 [ 2 Answers ]
 My sewage/ejector pump sometimes won't shut itself off. It has gradually gotten worse as time goes by. What could be causing this? Any suggestions appreciated. 
Sewage ejector pump
 [ 2 Answers ]
 
I had a home built over 2 years ago. We have a full finished basement with a bathroom and a laundry room. The builders installed an ejector pump to get the waste up to the street sewage line, and we have had problem after problem with it. 3 times over the past 2 years, the pump has been... View more questions Search 
  |