Ask Experts Questions for FREE Help !
Ask
    rwheels2's Avatar
    rwheels2 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    May 9, 2010, 07:30 PM
    Intertherm furnace
    Pressure switch not making on flue pipe side
    rwheels2's Avatar
    rwheels2 Posts: 3, Reputation: 1
    New Member
    		  
    #2

    May 9, 2010, 07:35 PM

    Pressure switch not making on flue pipe side
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks [ 3 Answers ]

I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Intertherm Furnace [ 1 Answers ]

The Hot surface ignitor comes on and lights the burner, but goes off after about 9 seconds. It repeats this and then locks out. What could be causing this. Intertherm Furnace: Model #MMHB-56ABHR-01

View more questions Search