Ask Experts Questions for FREE Help !
Ask
    ggefter's Avatar
    ggefter Posts: 4, Reputation: 1
    New Member
    		  
    #1

    May 9, 2010, 02:02 PM
    Furnace
    Happened today after I was trying to start again furnace
    6 years old
    Honeywell SV9541M "smart valve"
    It would not start burner, valve klicking sounds coming and going.
    In the intervals beetween every attempt green light flashing 6+2 times.
    Any advise?
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    May 9, 2010, 03:40 PM

    Probably gas pressure, but could be bad valve. Does piolt light?
    ggefter's Avatar
    ggefter Posts: 4, Reputation: 1
    New Member
    		  
    #3

    May 9, 2010, 06:22 PM
    Quote Originally Posted by Joshdta View Post
    probally gas pressure, but could be bad valve. does piolt light?
    Yes it does. Actually after shutting down completely ( Switch off) it starts but only for 2-4 minutes and stops again.

    Is it Valve?
    Should attempt to replace on myown or call for service people?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier furnace: limit switch fault furnace has ignition but blower will not come on? [ 2 Answers ]

Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks [ 3 Answers ]

I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.

Furnace Blower Motor Runs Constantly & Furnace or AC Won't Run [ 2 Answers ]

I have an Armstrong forced air (induced draft) natural gas furnace with central AC (made around 1990 -- Model: EG6H80DC14-1, Serial: A18315MNA). I had a problem at the end of the heating season where the blower motor would run continuously (even when the thermostat is turned to "off"). I thought...

Furnace not heating the house. Damper on the furnace not opening. Motor then shuts. [ 4 Answers ]

My forced-air furnace is not working correctly. The gas works heating the air in the furnace, but When the motor starts the damper doesn't open and the Motor shut down. I need suggestions?:mad:

View more questions Search