 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Condenser fan motor wiring
I have a Rheem heat pump and I replaced the condenser fan motor. The motor that I purchased is a Emerson 1861. I connected the white wire to the contactor, the black to the defrost board and the solid brown to the capacitor. The fan does not run. If I turn the blade the fan will start but once the unit stops the motor does not restart. O replaced the capacitor but I didn't replace the boost cap. Please help
|
||||
Check out some similar questions!
We just installed a new condenser fan motor (A.O. Smith OYK1028) and are feeling a bit lost with finishing up with the wiring. Both the old and the new motors (this is an OEM replacement) have three wires: purple, brown, and black. We did not remove the old motor, so we did not see how the wires...
Ijust replace the condenser fan on my rheem ac unit.The old fan had three wire brown yellow and black ,the new fan have four wire two browns yellow and black.I was told by the saleman to hook both brown to the new single capacitor and the yellow & black to the contactor.My old capacitor had a (c)...
I have purchased a new condenser fan motor to replace a faulty one but there are 2 additional wires. The new unit has a black,red,what,solid brown and brown and white wire where the original unit only has blk,brown and orange. The unit has a three way capacitor but I purchased a new capacitor which...
Hello How are you? I purchased a new fan motor and it has different wire colors than the old one. The old one has a black, brown and yellow wire and the new one has Brown, brown/white, White and black. How are these wired together. This is an outside A/C fan motor 1/4HP, 208-230 volts,...
Compressor tries to come on but trip breaker
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
