Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Concrete under Shower Pan after it's installed?
[ 19 Answers ]
Looking to reinforce my fiberglass shower by putting a hole in the wall on the side and shoving concrete or somethng else under there. Any suggestions? Not cracked yet, but it' "giving." also- toilet squeaks when we sit on it, and it seems to be coming from the conical crome part that sits flush...
Proper shower pan install utilizing exsting basement shower drain
[ 6 Answers ]
I am remodeling a basement bathroom. I demo'd the shower and its tile to reveal rotted framing. I believe this is due to an improper or (more likely) not existent shower pan -- there was no water proof membrane between the tile/thinset and the framing. Can I build a proper shower pan...
Removing drain assembly from shower, relacing shower pan
[ 1 Answers ]
How do I remove part of the old drain assembly that has been glued to the drain pipe that comes up from the slab floor.
My shower drain is raised above the shower pan by 3/16" causing standing water
[ 2 Answers ]
I have a fiberglass shower stall where the bottom has either slumped or the stall was installed wrong to begin with (it has no support beneath the surface that I stand on). The drain sticks above the level line so I have about 3/16" of standing water. I cannot easily access the bottom from the...
Removing shower drain for shower pan replacement
[ 1 Answers ]
I am in the process of removing an existing shower tray. I am having difficulty in removing the drain. It does not appear to screw in. I have access to from below if I need to cut pvc pipe. This appears to be the only thing keeping my tray in place at this time. View more questions Search
|