Ask Experts Questions for FREE Help !
Ask
    leebre's Avatar
    leebre Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 29, 2010, 07:14 AM
    I have a Jet Stream 5000, the spec plate only says 240VDC, anyone know the amps?
    I have purchased a GFCI 60 amp disconnect but want to make sure it is not to big for my need. The plate only describes the voltage. I was going to run a 50 amp but have not been able to find any information regarding the specs for this hot tub. I can send a pic of the pack if it helps
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Apr 29, 2010, 08:01 AM

    Your 60 amp breaker should be fine. :. Correct Tech Inc. - First quality products for Spa Control Systems, Hot Tub Spa Products-Spa Parts-Equipment Packs & Control Systems
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #3

    Apr 29, 2010, 11:54 AM
    A couple of observations;

    First is the title of your post states "240V DC"

    Is that a typo? Should be AC.

    Second, the spec sheet Ballenger found for you states there is a built in GFCI, so why the need for a GFI circuit breaker?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

50 amps vs 100 amps? [ 5 Answers ]

I recently purchased a new mobile home in Ventura, CA. The home was a "lot model" that was originally delivered from the manufacture and set up on a site, used as a model and then taken down and delivered to where I am now. The Manufacture says that it was built to run on 100 amps - it is 60...

Cost to upgrade from 100 amps to 200 amps and ground [ 4 Answers ]

StanFortyMan has made a lot of sense about my needs in a home with a 100 AMP Service.. I would like to upgrade to 200 amps.. with some ground sockets(or whatever this is called) and put in more sockets... The house is 1300 square feet... does anyone have a guestimate of costs?? Thanks, Annie

100 household amps vs 200 amps [ 6 Answers ]

I am living in an "old" house with 100 amps coming in. I am in the process of doing reconstruction and would like to know if I run all new wires and outlets and get rid of dusty broken wires and connection boxes left open to rot---Can I use the same fuses and wiring for 100 as for 200 or do I...

Changing from 100 amps to 200 amps [ 1 Answers ]

I have a gas water heater (40 gallon tank). I want to change it to an electric tankless water heater. I have read that I need 200 amps in the house to do this, but currently I have only 100 amps. The outside meter is located only about 25 feet away, but the lines are underground. What is...

Decorative Swith Plate or Wall Plate and Switches [ 5 Answers ]

We're looking to replace our standard switch plates with "decorative" plates, mainly in the kitchen backsplash. We have seen plenty of options for the plates, from pewter to copper to nickel, etc. Are there options for the actual switches themselves? Can we get switches, such as simple light...

View more questions Search