Ask Experts Questions for FREE Help !
Ask
    pole2009's Avatar
    pole2009 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 25, 2010, 11:28 PM
    Going from chimney to 10 inch
    Need to remove chimney below attic floor, then somehow connect a 10" at a 45 and run back out for the roof
    manhattan42's Avatar
    manhattan42 Posts: 143, Reputation: 11
    Junior Member
    		  
    #2

    Apr 26, 2010, 12:17 AM

    Assuming this is a masonry chimney: No can do.

    You will either need to reinstall a masonry chimney with an offset made to your specifications or line the entire chimney with an approved system from the chimney connector up and through the roof.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #3

    Apr 26, 2010, 06:48 PM

    What kind of chimney? Is this for a dfireplace, furnace or what, is it lined?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rounding to the nearest 1/2 inch and inch [ 4 Answers ]

Sarah was asked to round 4 7/8 in to the nearest 1/2 inch and to the nearest inch. Her answer was the same. Explain why Sarah is correct. Would it be 5 inches. :)

If your chimney is in the center of your house, do you need a chimney liner to vent t [ 2 Answers ]

If your chimney is in the center of your house, do you need a chimney liner to vent the water heater?

How do I connect 3 inch sch 40 to 3 inch copper . The o. D. Of the copper is 3 inch [ 2 Answers ]

I am remodeling an old house with all copper plumbing except for the cast iron that comes out of the basement floor. Some of the copper drain line is bad so I am trying to connect to the copper with sch 40 3 inch pipe. I can't seem to find a no hub band to make the connection. The o.d. of the...

Showere drain - can I reduce from 2 inch to 1 1/2 inch [ 1 Answers ]

Hi I have a few questions about replacing an existing bathtub with a shower as we remodel our bathroom, The existing tub on our upper floor was plumbed with a 1.5 inch p-trap and then a horizontal run of about 9 feet before it heads vertically downwards towards the basement between all the...

How to install 72 inch long by 4 inch tall Marble Vanity Backsplash [ 2 Answers ]

I just installed a new 72 inch long Marble vanity in my bathroom. It came with a 72 inch long by 4 inch tall Marble Backsplash. How do I install this backsplash? Do I just put an adhesive behind it? What about the gaps? How do I fill the gap of the top of the backsplash where it hits the...

View more questions Search