 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
New fan limit switch... fan still not shutting off.
I have a 30+ yr old lennox furnace and the fan will not shut off. I just replaced the fan limit switch and yet that didn't fix the problem. The thermostat is set to auto and so is the limit switch. Some of the troubleshooting I have done is setting the limit switch to manual and leaving the thermostat at auto, not sure if that would even work but I've tried it and it didn't. I'm sure I wired it correctly. The only thing I'm not sure of is the low voltage jumper tab on the limit switch. Its an expensive part and I didn't want to ruin it so I haven't broken the jumper. I tried reading the wiring diagram, to compare to other websites but that didn't help out too much. Is the jumper tab my problem or is it a relay or something? I've read through the other posts to find an answer but nothing so far. Is there anything I can do to rule out the limit switch as the problem?
|
||||
|
||||
|
When the thermostat is turned to the OFF position does the fan still run? In AC mode, the thermostat controls the fan. In heat mode the heater (limit switch) controls the fan. At 30 yrs, I'd suspect this unit might have a fan center and/or the relay that controls the fan stuck on. |
||||
|
||||
|
This is a "fan center" ZETTLER Controls Inc. - HVAC/R Products > Product Line It was used in older furnaces. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I need some help understanding the operation of a fan limit switch. What's the sequence of operation of this object. And how do one troubleshoot this part to determine if it's performing as it should. Thanks!:confused:
Where is fan switch located on Presidential II furnace
Hi everyone, Im new here. Well I have a 1987 Olsen Forced air furnace. I've been in this house now for about 4 months. I realized one day that the furnace fan didn't shut off. I did some searching and decided it must be a faulty fan limit switch. I got the correct Honeywell replacement limit...
Can you please tell me from what i.e. high limit and blower what side the wires would go . And what terminal does the power connect to the limit side or the fan side. Is there a common on the fan limit switch. This is for a Honeywell fan limit switch no a/c.
I am troubleshooting a Gas furnace. I am trying to eliminate the fan/limit control and a 24 volt electric controlled switch. I am getting 24 volts to the switch. I have replaced a thermostat for this unit. There is an auto/manual switch on the fan/limit switch. When this switch is in the manual...
View more questions Search
|
