Ask Experts Questions for FREE Help !
Ask
    chase198444's Avatar
    chase198444 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 3, 2010, 11:02 AM
    Thermostat wiring cooling but NO HEAT
    I need some help... I had a old hunter thermostat on my heater but it wouldn't turn on my cooling it was hooked up (RH-jumped to RC) and a red wire went to RC... W-White wire... G-Green wire... Y-Yellow wire and was set on (STD) not (HP) on back of thermostat but when I kicked on the cooling it wouldn't blow cool air just warm...

    So I bought a new hunter thermostat and Hooked it up like Y2-Yellow wire... RC/R-Red wire... W2-White wire... G-Green wire... B-Blue wire... and O-Orange wire... and put it in Heat Pump mode... But now I get cool air but when I switch over to HEAT I get nothing... The fan will not even kick on when I call for heat... What do I need to do to GET HEAT?. help

    'Thanks
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Apr 4, 2010, 12:16 PM
    Did you do a jumper from rc to rc?, you will be lucky if the Hunter is any good,, most are junk
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Thermostat wiring (Heat Pump) [ 10 Answers ]

Simple comfort 2200 to a Honeywell RTH7500. C-blue G-green Y-yellow O-orange R-Red E-Black B-Brown

.Heat only thermostat wiring. [ 2 Answers ]

I have an existing stat that has two wires coming out of the back. A blue one and a black one. The black is hooked to a black one in the box and the blue is hooked to a red in the box. On my new LUX LV2 stat there is a red line wire on the back and a black load wire on the back. What do I...

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

Thermostat wiring for heat pump [ 1 Answers ]

I am installing a Honeywell RHT7000 thermostat. My wiring harness has a r, o,y,g,c, and w1. On the old unit e and W1 were jumpered. What do I do when the instructions say to contact a contractor if the new wiring scenario has a w1?

Wiring from transformer to heat only thermostat [ 2 Answers ]

I have a honeywell hot water heat system(condo) with a control valve for the water, a transformer to supply power to the valve and a thermostat. The power supply was disconnected and I now need to reconnect a new transformer into the system. I have tried to use a 40VA transformer but I am concerned...

View more questions Search