 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
B&S fuel pipe elbow
I'm trying to replace the nylon fuel pipe elbow on a Briggs & Stratton 287707 engine. When the old one comes off the carb, there's a brass nipple that remains on the carb, and I haven't been able to remove it. The insert that came with the new elbow says I am to put the nipple in a vise and use 2 screwdrivers to pry the nipple off - they're assuming that the carb is off the motor. Is there any way to remove it without pulling the carb? The elbow is Craftsman PN 492790. Thanks!
|
||||
Check out some similar questions!
1997 Dodge Intrepid fuel pump & fuel filter
[ 5 Answers ]
Where is the in line fuel filter located and can the fuel pump be replaced by removing the rear seat?
PPr vs cpvc pipe- which pipe is better for plumbing & why?
[ 0 Answers ]
PPR vs CPVC pipe, which better for plumbing & why?
Replacing a honda fuel pipe
[ 1 Answers ]
I have a 91 model honda civic 1.3 I need to remove and replace the fuel pipe going to the fuel tank but it a tight fit any tips on how best to do this
Fixing an elbow on a pipe against an outside wall?
[ 5 Answers ]
I have a leak on an outside pipe coming from the 90 degree elbow bend (I think). I have wrapped it in that hardening tape, but it still leaks (much less now). I would like to fix the leak completely, but here are my problems. The pipe is right up against a wall, so getting around it is pretty...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
