Shower stall construction

WoodBox Posts: 1, Reputation: 1

New Member

Mar 22, 2010, 04:45 PM

Shower stall construction

I'm Installing A corian solid surface shower with a custom cultured marble pan. What should the wall sub surfaces be behind the Corian sheets?

speedball1 Posts: 29,301, Reputation: 1939

Eternal Plumber

Mar 24, 2010, 04:43 PM

B ump

Add your answer here.

Check out some similar questions!

How big should the cut out be for a shower handle on a stall shower [ 1 Answers ]

I am in the process of having a stall shower installed and the handyman has cut a large hole in the wall to get the shower handle through the side of the shower. This hole will be covered up by the metal covering for the shower handle but I'm concerned that there's such a large hole under the cap....

Fiberglass shower stall, new shower set [ 4 Answers ]

We just bought a new shower set for our bathroom but found out we have a problem. It's a fiberglass, 1-piece tub/shower and the hole where the valve comes out is too small to remove the old one. We have two bathrooms and the other tub/shower is back-to-back with the one we're trying to change. This...

Shower stall need height of controls and shower head [ 1 Answers ]

Hi Am building a shower and require the height of the taps and the shower head

Custom shower stall construction [ 3 Answers ]

Hello, Could you give me specific steps to build custom shower base - what is the best membrane to install in the shower base, how to do it as well how to attach it to shower drain Thanks Bogdan

Turning walking shower stall into bathtub/shower combo. [ 4 Answers ]

Question: Current shower drain (2" pipe) runs 5 feet, under slab, to vent stack (5" cast iron vent pipe) of toilet. Will need to move the drain 3ft to wall for new tub. After moving the drain, the complete length of the pipe will still be around 5 feet. We will have to reduce the drain line...