Ask Experts Questions for FREE Help !
Ask
    daviddube's Avatar
    daviddube Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Mar 20, 2010, 12:28 AM
    Constant high idle (4500rpm) d15b vtec 94
    I have a honda civic 95 with a d15b vtec single stage 94 I recently had probleme with my igniter unit so I replace de igniter unit and the ignition coil from the distributor of the original engine of the car (d15b not vtec) since its done my engine si run at cevry high idle (4500rpm) what this could be?? Some one have a troubleshooting for this problem ?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Mar 20, 2010, 05:55 AM

    It sounds like the igniter and coil are not the correct ones for your new engine. Install the correct parts, remembering to apply silicone heat transfer compound to the back of the igniter.
    daviddube's Avatar
    daviddube Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Mar 21, 2010, 08:44 AM

    I asked some question to my nearest honda dealer and they confirm me that if the igniter unit wasn't compatible the car would not start and the coil is the same part number.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

93 honda civic constant high idle 4500 rpms [ 2 Answers ]

Hi, I have a 93 honda civic with a constant high idle. It idles at 4500 rpms then will drop to 2500 as it heats up I have change the idle air control and the map sensor but nothing. However when I cover up one of the holes in the throttle body (because I have two I don't know if its normal) the...

High idle [ 1 Answers ]

I have a 1989 chevy blazer with a 5.7 liter. I have changed temp sensor and throttle position sensor, but still have high idle. Wondering what else to check to remedy problem?

High Idle [ 1 Answers ]

I have a 94 Grand Am 3.1 liter engine that while in park idles at about 2500 RPM and when you put it in gear may go down to about 1500RPM. After warming up a bit it might drop to about 2000 RPM. Didn't see any obvious problems.

View more questions Search