Ask Experts Questions for FREE Help !
Ask
    sweethudy@yahoo.com's Avatar
    [email protected] Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 19, 2010, 05:13 PM
    Honeywell magicstat manual
    My Honeywell MagicStat thermostat indicates 'system on', but my furnace is not on and the current temperature in my house is 10 cooler than what I have programmed it to be (during the heating season). I have found turning the thermostat to 'off' and then back to 'auto' gets the furnace to start, but the problem persists the next time the temperature falls below the programmed setting
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Mar 19, 2010, 05:34 PM

    What brand furnace do you have? Look in the bottom door for a flashing light.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell thermostat manual th411od [ 3 Answers ]

Is quite cold in Boise Idaho todayl Daughter is living in rental house we own (!yr old). The thermostat read Recovery. What does that mean. She said it is running now, just don't want it to shut down, and risk freezing pipes... Would it be the timer getting messed with? Jilda Ballweber

Honeywell MagicStat 32 - Model CT3200 [ 9 Answers ]

Hi, I have a Honeywell Thermostat MagicStat/32 which is saying (not Flashing) "bat low." As per the instruction manual, I changed the Batteries. This did not clear the screen. I tried another set of new Batteries, which again did not clear the screen. I am sure I put them In correctly. ...

Honeywell Magicstat 32 Model CT3200 [ 4 Answers ]

Help: The reading on my CT3200 is higher from the room temperature by at least 2 degrees Celsius during the heating season. I measured the temperature with a digital thermometer which read 20 degrees Celsius and my CT3200 was reading 22 degrees Celsius. It's on an inside wall which is well...

Honeywell MagicStat/32 or Furnace Failure? [ 4 Answers ]

I've changed the batteries on the thermostat when the "lo bat" message displayed. Per the user manual, I had to install the batteries backwards for 10 seconds in order to reset the unit. I then reinstalled the batteries in the proper manner and began to program the unit. Approximately 20 seconds...

Honeywell MagicStat 32 - Model CT3200 [ 2 Answers ]

Hi, I have a Honeywell Thermostat MagicStat/32 which is saying (not Flashing) "bat low." As per the instruction manual, I changed the Batteries. This did not clear the screen. I tried another set of new Batteries, which again did not clear the screen. I am sure I put them In correctly. ...

View more questions Search