Ask Experts Questions for FREE Help !
Ask
    hanmardawn's Avatar
    hanmardawn Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 17, 2010, 06:12 PM
    Moving weight bearing walls in the attic
    Building a bedroom in attic, need to move studs back but afraid of roof falling in.
    Fr_Chuck's Avatar
    Fr_Chuck Posts: 81,301, Reputation: 7692
    Expert
    		  
    #2

    Mar 17, 2010, 06:28 PM

    It is very expensive to move a load bearing wall, proper beams and supports have to be in place.

    You will need to have a professional come in and give you estimates to do it
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
    		  
    #3

    Mar 17, 2010, 11:43 PM

    What is length of rafter?

    Where is wall located on length of rafter from ridge down?

    What is location of collar ties from ridge down?

    What is pitch of roof?

    Answer these questions and we will be able to help u.

    Chuck
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #4

    Mar 18, 2010, 05:29 PM

    You likely need to pull a permit and this could force you to get an architect or structural engineer drawings and stamp. I would not fell comfortable giving you further advice unless I could see your blueprints, this usually is not a DIY job
    freedhardwoods's Avatar
    freedhardwoods Posts: 42, Reputation: 3
    Junior Member
    		  
    #5

    Mar 20, 2010, 03:31 PM

    I would have to see the exact situation, but I think it would be a fairly simple project. I deal with Amish work crews all the time. Depending on how big the room is, they would probably have the walls moved ( and possibly drywalled) in 1 day or less. They are very fast and efficient workers.

    I agree with ballengerb1 though. Depending on where you live you will probably have to deal with permits, architects, etc. In this area, we don't have to deal with that as much as other areas.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Do I have load bearing walls? [ 5 Answers ]

I live in a small house. The lot is 80 x 20 and it is attached on both sides to other houses. It has a poured concrete and cinder block basement and plaster and lathe 1st and 2nd floors. There are no walls that run the length or width in the interior of my house and no walls that are directly above...

Load Bearing Walls [ 21 Answers ]

How can you tell if it a interior wall or a Load Bearing Walls

Load bearing walls [ 4 Answers ]

I have a 29 foot load bearing wall. I am going to leave 4 ft. then tear down a 7ft section and then will have 18 ft still standing. Will the wall still stand or do I need to support it somehow? Thanks for taking the time to help out.

Load Bearing Walls [ 1 Answers ]

I am confused about what are the joist and not the joists in my basement. It is a 100 year old house. I have one main bean that runs front to back (supported by columns- the kind with a large cement bottom you might see when building a deck, the term is escaping me at this moment- in basement)...

Load bearing walls [ 1 Answers ]

When replacing a load bearing wall what size lumber do I need to support a second story floor when the opening is 16ft. This wall is in the center of the house which is 24ft wide

View more questions Search