Ask Experts Questions for FREE Help !
Ask
    nancy67's Avatar
    nancy67 Posts: 8, Reputation: 1
    New Member
    		  
    #1

    Mar 17, 2010, 05:49 AM
    Standing pilot
    I have a problem with my pilot to stay on.I cleaned the orfice and installed new thermocouple.and still don't stay on.it a comort aire furnace.just wondering if the gas valve needs to be replaced.thank for
    Comments.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Mar 17, 2010, 09:30 AM

    I have seen new t-couple bad out of the box. Is your flame hitting it good?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Pilot is lighting on home heater but no hot air and pilot is lighting but it continue [ 0 Answers ]

Here is my problem The hot air is not coming out from a/c ven Heat was working two days ago Pilot works but it starts then goes out or low then starts again but gas to burner doesn't start main burners for heater Tried circuit breaker and on/off switch and pilot screw adjust which did not...

Old lennox with standing pilot and cam stat cycling [ 8 Answers ]

Hi gents Old lennox model 9803-980-2 H.boy 68000 BTU with a honeywell fan limit cycling every 5minutes . The wires disconnected at the Stat and jumpered . Still the furnace acting same problem . The motor and blower wheel and pilot acting quite normal . Do you think the fan limit is faulty...

Gas furnace has an intermittent pilot, pilot lights, furnace tries to start [ 3 Answers ]

Have a 25 plus year old furnace pilot will start when signal sent furnace tries to start makes noise as it tries over and over but will not start. Thanks

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...

View more questions Search