 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Hi all, Unsuccessfully tried to cap a copper water line by soldering a pre-soldered cap onto the end. Took all the proper steps, cleaned the ends of the pipe and fitting first, then applied flux around both. Wasn't quite sure what I should be heating, so I just heated everything. After my first...
I am at my wits end I know this is supposed to be an easy fix but I have been trying to cement the compression shut off valve to a cpvc pipe and it pops completely off after 5 hours of drying time as if there was no cement at all. Any suggestions its nw 1:30 am here and my main water is still off.
Hi, I just noticed that the cap of the water shut off valve of my toilet is not big enough to cover up the entire hole on the wall so there is a small gap on the wall. I suspect (and hope) the plumber probably drilled the hole too big when they installed the toilet (my place is 10 years old). ...
I have a constant drip in my bathroom sink. After a little trouble shooting, I came to the conclusion that my hot water valve underneath the sink is the culprit. I traced the pipe down the wall, into the basement and to the water heater. The only thing between the water heater and the old valve in...
I recently replaced an old, leaky shut-off valve with a compression shut-off valve. I cut off the copper pipe cleanly and made sure the end was clean and burr free. After tightening the nut as instructed, I still had a leak from where the valve connects to the stub. I've adjusted it a couple of...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
