Ask Experts Questions for FREE Help !
Ask
    alunthomas's Avatar
    alunthomas Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Mar 3, 2010, 09:11 AM
    How to change bulbs on a toyota granvia
    I can't remove the back light cluster on the back door of my toyota granvia to change the bulb on the stop light. Pleas help
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Mar 3, 2010, 09:15 AM

    I'm not familiar with your vehicle, but you likely need to remove an inside panel for access.
    alunthomas's Avatar
    alunthomas Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Mar 3, 2010, 10:00 AM
    I have removed the back panel off the rear tail gate, and you can see were the bulbneeds to go but the space is very tight toget the bulb in or out. I have tried to pop the cluster off from the side, but something seems to be holding it back. Any ideas . Thanks
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #4

    Mar 3, 2010, 10:05 AM

    Even though this link is for a Taurus, it may help you with replacing your rear bulbs:

    https://www.askmehelpdesk.com/cars-t...ml#post2092806

    The procedure is pretty much the same on most cars.
    VKCC2010's Avatar
    VKCC2010 Posts: 1, Reputation: 1
    New Member
    		  
    #5

    Sep 16, 2010, 11:56 AM
    You need to remove the liner panel inside the door (first take out the two plastic screws in each lower corner) then 'pop off' the retaining lugs all the way round, plus three more in the middle. Then romove the clear plastic moisture sheet - fixed on with black mastic all round the edge. Now locate a round hole in the inner metalwork - situated behind the reversing light - this has a 10mm bolt on a long thread. Remove the nut and push the threaded bolt out towards the outside of the tailgate.
    (It may need a tap with a piece of wood and a hammer). The from the outside, prize off the light unit from the outer edge and it all comes loose.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Changing brake light bulbs on 96 Toyota Camry Station Wagon [ 4 Answers ]

I need to change a brake light bulb in the tailgate of my 1996 Toyota Camry Station Wagon. I have a Chilton's repair guide but it says nothing about the lights in the tail gate. How do I can access to change the bulbs? Thank you.

How do I change a timing belt on a 94 toyota camery 2.2l engine [ 2 Answers ]

How do I change the timing belt and water pump on a 1994 Toyota Camery with a 4cyl eng.

Change light bulbs in a fan [ 1 Answers ]

How to change bulbs of a 52" Romano ceiling fan

Toyota Granvia starting problems [ 1 Answers ]

Hi, We have a 96 Toyota Granvia import. Brill car, except that for the past few weeks it has had intermittent problems starting. We have had to keep getting the battery out for an our to charge fully before putting it back in to start. It seems to be fine for a few days and then nothing - not...

View more questions Search