Ask Experts Questions for FREE Help !
Ask
    on demand's Avatar
    on demand Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 28, 2010, 12:18 PM
    Symmons temptrol
    I have a Symmons Temptrol with a problem. I recently installed an on demand hot water heater and when I was done, I can't get a hot bath. Really hot shower, but not a hot bath. I am trying to get the T-31 knob off and I can't get it off the spline on the TA-10. Been there 30 years. Any suggestions? Yes, I did take the little screw out.
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
    		  
    #2

    Feb 28, 2010, 01:33 PM

    You will need to get a puller see the image below, good luck.

    John
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Symmons - Temptrol Diverter [ 22 Answers ]

I have the above diverter in my bathroom. Recently it started to leak from the diverter handle that changes the use from tub to shower. I purchased the Symmons TA-25A Iverter Spindle to replace old. My problem is that I do not know how to remove the old spindle. Can anyone help me with my problem?

Symmons temptrol leaking [ 0 Answers ]

This is a symmons-temptrol. Leaking only at the tub spout. I don't know the model number but it is able to divert to either shower or tub. The tub spout leaks. What internal part should be replaced. I have a schematic listing parts T1 all the way to T55-c. The parts are further grouped in several...

Symmons '76 Temptrol Model A [ 19 Answers ]

Hello, I purchased a TA-10 to replace the spindle in my Symmons '76 Temptrol Model A. After removing the original spindle I notice that the replacement part is different. Namely, there is no thread on the largest circumference part on the replacement part whereas the original has a thread....

Symmons temptrol - no water [ 2 Answers ]

I'm getting nothing but a dribble on hot and cold, tub or shower settings. Was fine until today. Any way to tell if it is the valve or seat? There's nothing else to replace, right? Thanks

View more questions Search